- Aggregates Manager - http://www.aggman.com -

Leading Edge Attachments: High-cap, multi-ripper bucket

Posted By cprewitt On February 17, 2012 @ 1:20 pm In Aggregates Zone,New Products from Aggregates Manager | No Comments

[1]The Leading Edge Attachments Inc.’s patented High-Cap Multi-Ripper Bucket can replace hammers, blasting and rock trenchers, for a fraction of the cost, by being the highest quality and most productive rock ripper bucket combination available on the market.

The High-Cap Multi-Ripper Bucket is manufactured in USA, but utilizes the worldwide patented “SHARC” (SHanks on an ARC) Technology, meaning that the bucket functions similarly to that of a trencher except it uses the hydraulic excavator rolling action to rip. The staggered ripper teeth fracture the substrate in sequential order, so that the rolling of the Multi-Ripper Bucket, by extending the bucket cylinder, always provides maximum breakout force applied sequentially to each tooth. The results are flat ripped sides and bottom surfaces replacing rock trenchers for a tremendous cost savings.

  • Patented staggered shank on an arc design allows the excavator operator to dig through rock, coral or frozen ground.
  • Rips the sides and bottom of the trench flat with no depth limitations.
  • Delivers close to 8 times the force of a standard excavator bucket.
  • Is 4 times faster than using a hydraulic hammer.
  • Outperforms any other style rock bucket 2 to one.

Also,

  • Can be used in place of a rock trencher.
  • Can be used to rip rock instead of blasting.
  • Supplied with powerful MTG KingMet™ Systems teeth.

Available for any excavator above 6,000 pounds.


Article printed from Aggregates Manager: http://www.aggman.com

URL to article: http://www.aggman.com/high-cap-multi-ripper-bucket/

URLs in this post:

[1] Image: http://www.aggman.com/files/2012/02/LEA-Hi-Cap-Multi-Ripper-Buc.gif

Copyright © 2009 Aggregates Manager. All rights reserved.