MSHA posts new citations to enforcement Web site
New citations have been posted to the Mine Safety and Health Administration (MSHA) Enforcement Alerts Website. The Illinois Association of Aggregate Producers (IAAP) and other Midwest aggregate associations maintain the Web site.
The new citations as reported by IAAP are as follows:
Date: June 27, 2011
Condition: The existing guard for the overhead furnace fan in the breakroom building is not adequate to prevent contact with the fan blades. The existing guard has openings approximately 2 to 3 inches wide and 6 inches long. The fan is located on the back of the furnace about 75 inches above the floor.
The location of the furnace in the southeast corner of the breakroom and the location of the fan on the back side of the furnace make contact unlikely. This condition exposes miners to cuts, bruises, and/or broken bones associated with contacting the rotating fan blades. The condition was not open or obvious because of the location. The mine operator was unaware of the condition.
Action: The operator provided an adequate guard for the-furnace fan in the breakroom.
For more information about this citation, go to http://mshaenforcementalerts.com/citations.php?id=314.
Date: June 27, 2011
Condition: The stop/brake lights provided on the Cat 988 F front end loader S/N
The stop/brake lights provided on the Cat 988 F front end loader S/N 8YG are not functional at this time. The front end loader is operating in the pit area of the mine loading material into the primary crusher. Two other haul trucks are operating in the pit area to access load out bins on the north side of the crushing plant. This exposes a person operating the other mobile equipment to the hazard of not being alerted to the front end loader stopping, causing a collision which could result in strain or sprain injuries.
Action: Fixed the brake lights.
For more information about this citation, go to http://mshaenforcementalerts.com/citations.php?id=312.
Date: June 24, 2011
Condition: The operator had an air pressure tank with a pressure gauge that was located along an air line past a gate valve. This gauge could not continuously give an accurate reading of the pressure within the tank should the gate valve be closed. At that point when this gate valve is closed the gauge would only be reading the pressure within the air line. A miner not knowing what the accurate air pressure is within the tank could have it rupture, resulting in lost work days or restricted-duty type injuries. Miner had an outside source check the air compressor unit for safety and did not notice the discrepancy.
Action: The operator placed a properly functioning gauge on the end of the tank which will give continuously correct reading of the pressure within the unit.
For more information about this citation, go to http://mshaenforcementalerts.com/citations.php?id=311.
From our partners
Sandvik Construction launches the newly developed CH540 cone crusher - the latest…
MORE FROM Aggbeat Online
SUBSCRIBE & FOLLOW
- Worker airlifted to hospital after accident with rock crusher486 Views
- 10-year-old boy falls 30 feet into NY quarry389 Views
- Cat rolls out its 6020B hydraulic shovel, matches 777G haul trucks383 Views
- VIDEO: Excavator scrapes 50 tons of sharp rock out of 2015 F-150315 Views
- Unexpected sand and gravel causes rollover accident280 Views