- Aggregates Manager - http://www.aggman.com -

Terranox DTH Hammers Added to Atlas Copco Geotechnical Drilling Equipment Package

Posted By cprewitt On April 18, 2011 @ 10:58 am In Aggregates Zone | No Comments

[1]March 23, 2011 – Commerce City, CO –Atlas Copco announces the addition of the Terranox DTH (down-the-hole) hammer to its package of geotechnical drilling equipment.
The Terranox range of DTH hammers are designed for percussive geotechnical drilling in low pressure operations.

Low pressure drilling becomes important when drilling in overburden ground conditions as air from DTH drilling may un-consolidate the ground, thereby decreasing the capacity of existing foundations.

In these circumstances, lower air pressure (in the range of 174 to 261 psi) is recommended, and it was for these conditions that the Terranox DTH hammers were designed.
The Terranox DTH hammer utilizes the proven DHD shank on the bits and the Symmetrix pilot bit. It comes in five sizes, designated Terranox 3, 4, 5, 6, and 8.

The Terranox 3 is 35-1/2 inches long, with an outside diameter of 3-1/8 inches. Sizes range upward to the Terranox 8, with a length of 56-13/16 inches and an outside diameter of 7-1/8 inches.

Choosing the right hammer is largely determined by hole size and type of ground conditions. Ideally, the size of the hammer should match the required hole dimension as closely as possible,
leaving just enough space for cuttings to evacuate the hole.


Article printed from Aggregates Manager: http://www.aggman.com

URL to article: http://www.aggman.com/terranox-dth-hammers-added-to-atlas-copco-geotechnical-drilling-equipment-package/

URLs in this post:

[1] Image: http://www.aggman.com/files/2011/04/014-Terranox.gif

Copyright © 2009 Aggregates Manager. All rights reserved.